User's Manual

Status Normal
Battery
Low
Battery Critical Battery
Power on
On in
green
for
1
second
On in
green
for
1
second
Flashes in
red
three times per
minute.
Start mode
(pinging for the
meter)
OFF OFF
Flashes in
red
three times per
minute.
Communicating
with Meter/Hub
Flashes in
green
once
per second
Flashes
in
green and
red
alternatively
Flashes in
red
three times
per
minute.
Transmission
completed
Blue is on
for
5 seconds
Flashes
in
blue and red
alternatively
Flashes in
red
three times
per
minute.
Transmission
fails
/
Lost
Flashes
in
red
Flashes in
red
very quickly
Flashes in
red
three times per
minute.



• Hold the Wireless SmartClip and pull the meter from the left-
hand side with some pressure.

OPERATION

After the Wireless SmartClip is installed onto the meter, you need to
turn on the Wireless SmartClip to ensure the transmission works.
Make sure you power up the coagulation meter in priority of turning
on the Wireless SmartClip.

The effective distance between a counterpart station, such
as
a hub, and the coagulation meter should be not far from each
other more than 10 meters or 32.8 feet
data from the Wireless SmartClip. Please wait until
the
connection has been re-established automatically.
• Note: If you measured your prothrombin time (PT)
without
data transmission, the collected PT values will be
automatically transmitted once a data connection will be
established again.

Turn off the Wireless
SmartClip:

• Slide the switch to OFF after having ensured a successful
data transmission .

The effective distance between a counterpart station, such
TM
Turn on the Wireless SmartClip:
as a
2net hub, and the Wireless SmartClip should be not far from

• Slide the switch to ON. LED indicator lights up briefly in
green (given a normal battery status).
• Run a prothrombin time (PT) measurement with the
Roche
CoaguChek XS meter, as described in the operating manual
of the meter.
• Once the PT measurement result is shown on the display
of
the CoaguChek XS meter, please do not turn off the meter,
until the data transmissions will start automatically (within 60
seconds), which will be indicated by a green flashing LED.
• Ensure that the blue LED indicates that data
transmission
was successful (steady or flashing according to the table
below).
• Once you saw the blue LED, your PT data has
been
transmitted successfully.
• If there is no blue LED, please make sure that the
receiving
device (e.g. 2net
TM
hub) is turned on and able to receive the
each other more than 10
meters.

LED INDICATOR