User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N doc: MN/2009/071 - Rev. 1.1
IBIS-S v. 1.0 - User Manual
Config.: IBIS-S-PRCS-OUT-MN
41 / 48
All information contained in this document is property of IDS. All rights reserved.
5.3 Dismantling IBIS-S
1. Close the IBIS-S Controller application and turn off the PC;
2. Disconnect the power supply cable form the sensor and then from the battery.
3. Disconnect the USB cable from the PC and then from the sensor.
4. Disconnect the transformer from the PC and then from the battery.
5. Screw the protection caps onto the two IBIS-S sensor connectors .
6. Remove the optical telescope from the IBIS-S sensor by loosening the screws and
sliding it out of the guide;
7. Remove the two IBIS-H20 antennas from the sensor.
8. Reposition the antennas in the appropriate place in the IBIS-S case.
9. Keeping firm hold of the sensor, unblock the quick lock mechanism on the
triaxial head (we recommend this operation is performed by two operators; one
keeping hold of the sensor, the other unblocking the quick lock mechanism).
Fig. 5.19 – Removing the sensor from the three axial head
10. Remove the IBIS-S sensor, lifting it off of the triaxial head.
11. Place the sensor on one side and loosen the external fixing nut on the hexagon.
12. Unscrew the hexagon from the bottom of the IBIS-S sensor, acting on the metallic
nut and screw on the back of the hexagon on the triaxial head.
13. Replace the IBIS-S sensor in its position in the IBIS-S case.
14. Remove the triaxial head from the tripod by rotating the azimuth control handle
anticlockwise (the handle must be securely tightened).