User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N°doc: MN/2009/070 - Rev. 1.1
IBIS-L v.02.00 - User manual
58 / 65
All information contained in this document is property of IDS. All rights reserved.
6. once started, the program performs a rapid check up of the peripheries and is
ready for use (the measurement session history panel displays the “verifying
configuration” message);
7. to check the correct functioning of the apparatus, click the Change
Configuration button and from the Configuration Panel that opens. Try to
move the sensor along the track using the buttons located in the bottom left of
the window (<<, <, >, >> and STOP). Then press the go home command,
which returns the sensor to the centre of the linear scanner;
Fig. 5.2 – The configuration panel
8. once the sensor Homing operation is completes, press OK;
9. check that the system has accepted the configuration (the “Configuration
Changed” message appears in the Measurement’s Session History panel).
At this point, the instrument can be used following the instructions provided in the IBIS-L
Controller software manual.