User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N°doc: MN/2009/070 - Rev. 1.1

IBIS-L v.02.00 - User manual

42 / 65

4. IBIS-L SYSTEM INSTALLATION PROCEDURE

Installation of the IBIS-L system requires about 2 hours work to install plus the time

required to build the base and the setting time for the two component resin used to fix the

studs (about 30 minutes at 25°C). The procedure can be broken down into two parts:

1. Installation of the linear scanner;

2. Installation of the IBIS-L sensor and connection of the modules.

After these two procedures have been described, the procedure for dismantling the

equipment form the measurement site is given in Par. 4.3.

4.1 Installation of the linear scanner

The procedure starts with an initial inspection of the site, during which the location for the

installation must be established, and finishes with the installation of the linear scanner.

Note that when re-positioning the module on a pre-existing installation site, only the small

group of operations indicated in par 4.1.3 are required, which relate to the setting up of the

linear scanner.

4.1.1 Material required

The following material is required to install the linear scanner:

1. a solid and stable base in concrete or other non-conductive material that is

sufficiently wide, flat and horizontal; minimum dimensions: 2000mm x 800mm x

200mm (length, width, thickness) (see Par.6.1);

2. IBIS-L box containing the linear scanner;

3. IBIS-L trolley case complete with anchoring elements;

4. spirit level (not supplied);

5. carpentry tools (not supplied) including:

a. hammer drill;

b. set of three masonry drill bots ∅ 8, ∅ 14 e ∅ 18 mm and two metal bits

∅ 20 and ∅ 22 (see par. 6.1);

c. two 24mm spanners;

d. spray, pencil or marker pen to mark the holes;

e. compressed air cylinder to clean debris from the holes made in the base;

f. water repellent silicon grease;

g. water repellent silicon oil;

h. two component resin with dispensing spout and cartridge gun.

To remove the components from the IBIS-L box:

NOTE

: IDS supplies the kit for the first installation. If multiple installations are to be

made, a kit must be acquired for each successive installation.