User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N°doc: MN/2009/070 - Rev. 1.1

IBIS-L v.02.00 - User manual

36 / 65

When transporting the module, the handles should always be folded down following the

procedure below:

1. loosen the lower screw of the handle blocking mechanism

2. completely unscrew the top screw on the handle blocking;

3. rotate the handle clockwise (towards the front of the module) until it touches the

wheels;

4. reinsert and screw in the previously removed screw;

5. tighten both screws.

Fig. 3.21 - Sequence for unfolding the power supply unit handles

Opening the top door of the power supply module accesses the housing and work space

for the control and data acquisition PC and the power supply electric switchboard (see

Fig. 3.22). The PC workspace is fitted with:

• A Velcro strap to block the PC;

• A power supply cable for the PC

• A USB cable to connect the PC to the linear scanner and then to the IBIS sensor.

The cable connecting the power supply module to the mains electricity is located

underneath this top door

Fig. 3.22 –The notebook PC table