User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N doc: MN/2009/071 - Rev. 1.1
IBIS-S v. 1.0 - User Manual
7 / 48
A
ll information contained in this document is property of IDS. All rights reserved.
I
MPORTANT NOTE FOR THE US CUSTOMERS
Model No.: IBIS-KU
FCC ID: UFW-IBIS-KU
This device complies with part 90 of the FCC Rules.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your
authority to operate this equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum 20 cm between the radiator and your body. This
transmitter must not be collocated or operating in conjunction with any other antenna or transmitter unless
authorized to do so by the FCC.
IMPORTANT NOTE FOR THE CANADIAN CUSTOMERS
Model No.: IBIS-KU
IC ID: 8991A-IBISKU
This device has been designed to operate with the antennas listed below, and having a maximum gain of 22 dB.
Antennas not included in this list or having a gain greater than 22 dB are strictly prohibited for use with this device.
The required antenna impedance is 50 ohms.
IBIS-ANT1-H38V18
IBIS-ANT2-H29V25
IBIS-ANT3-H17V15
IBIS-ANT4-H11V10
IBIS-ANT5-H12V39
IBIS-ANT6-H51V20
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.