User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N doc: MN/2009/071 - Rev. 1.1
IBIS-S v. 1.0 - User Manual
31 / 48
A
ll information contained in this document is property of IDS. All rights reserved.
5. IBIS-S INSTALLATION AND DISMANTLING PROCEDURE
The IBIS-S system has been designed to be fast and simpl
e to install. The complete
procedure takes about 20 minutes to have the instrument ready for operation. The same
time is required to dismantle it.
The following section describes all the material required (Para. 5.1) and the steps to
follow to correctly install (Para. 5.2) and dismantle(Para. 5.3) IBIS-S.
5.1 M
aterial required
The material required for installation includes:
• IBIS-S case;
• Bag containing tripod;
• Small tapered cross slot screwdriver (not supplied).
Proceed as follows to remove the various parts from the case:
1. sit the IBIS-S case on the ground;
Fig. 5.1 – The IBIS-S case
2. open the 7 catches around the IBIS-S case and lift the lid;
3. after removing the protective layer, you will see:
a. 2 batteries;
b. 1 battery charger;
c. 1 three axial head;
d. 1 PC power supply converter for battery;
e. 1 optical telescope
f. 1 USB cable and 1 sensor power supply cable