Technical Manual

IDS Ingegneria Dei Sistemi S.p.A.
N doc:MN/2011/004 - Rev. 1.1
18 / 19
Tutte le informazioni sono di proprietà IDS. Tutti i diritti riservati.
All information contained in this document is property of IDS. All rights reserved
Insert the 4 cylinders within the 4 nuts of the vehicle wheel and then apply on
them the bigger disk, screwing it to them by fixing 4 bigger screws; then apply the
smaller disk to the bigger disk by fixing the 4 smaller screws to the prefixed
smaller cylinders. Keep vertical the encoder cable and apply the magnet located
on its limb to the vehicle metallic side (see Fig. 2-11 and Fig. 2-12).
Fig. 2-11 – Particular of the wheel mechanical kit
Fig. 2-12 – Particular of the wheel encoder kit
BIGGER
CYLINDER
BIGGER
SCREW
BIGGER
DISK
STAR PREFIXED
TO BIGGER DISK
SMALLER
CYLINDERS
WHEEL ENCODER
CABLE
SMALLER
SCREW
SMALLER
DISK
ENCODER