Technical Manual

IDS Ingegneria Dei Sistemi S.p.A.
N doc:MN/2011/004 - Rev. 1.1
17 / 19
Tutte le informazioni sono di proprietà IDS. Tutti i diritti riservati.
All information contained in this document is property of IDS. All rights reserved
Fig. 2-9 – Particular of the belts
5. Insert the horn antenna onto the fiberglass frame in its proper place, located at the
extremity of the frame C, between 2 black cross rubber bars; then fix the top of
the antenna with the 2 straps already assembled properly.
6. The encoder kit (see Fig. 2-10) is composed by:
a. 4 metallic cylinders (Ø17, or Ø19 or Ø21)
b. 1 bigger metallic disk + 1 metallic star + 4 bigger screws
c. 1 smaller metallic disk + 1 encoder + encoder cable + 4 smaller screws +
magnet.
Fig. 2-10 – Encoder wheel kit view
BELTS