Technical Manual

IDS Ingegneria Dei Sistemi S.p.A.

N doc:MN/2011/004 - Rev. 1.1

14 / 19

2. PROCEDURE OF ASSEMBLING

Here below you find the steps to assemble the Hi-Pave GPR system. Of course it’s

necessary to get a vehicle provided with a hook on the back side and possibly a carrier or

similar on the roof/back of the vehicle itself. Please follow the steps in order one by one.

1. Take the metal key (provided with the system) and unscrew the screw on the

vertical frame (see Errore. L'origine riferimento non è stata trovata.), until the

frame fits on to the hook of the vehicle. Then screw it again strongly keeping the

frame vertical as much as possible (Fig. 2-1).

Fig. 2-1 – Screw on the vertical frame

2. Make slide the horizontal frame (B) on the vertical frame (A), and fix B to A

applying 4 screws M8x20, attaching them to the 4 brackets and verify that the B

is horizontal and parallel as much as possible to the ground surface (see Fig. 2-2

and Fig. 2-3).

Fig. 2-2 – Horizontal frame attached to Vertical frame

HOOK

SCREW

VERTICAL

FRAME (A)

HORIZONTAL

FRAME (B)