User's Manual

IDS Ingegneria Dei Sistemi S.p.A. Protocol: MN/2009/056 - Rev. 1.0

RIS Hi-Mod - Installation Guide and User Manual

Fig. 2-9 – Connecting the DAD Control Unit to the battery pack and switching on

button (red color)

Press the red button to switch on the DAD control unit (Fig. 2-9). This button has

to be kept pressed until the blue on switch lights up. If the K2_FW software is not

activated within 30 seconds, the indicator light will start to flash. As soon as the

K2_FW software is activated the indicator light stops flashing and appears a

constant blue light. If, however, the Software is not activated within about 2

minutes 30 seconds, the DAD unit will automatically shut down. Once the

K2_FW software has been shut down, the indicator will flash for about 30 seconds

and will automatically shut down after 2 minutes.

W ARNING

DON’T CONNECT the

Battery Cable

to the

Remote

connector

found on each IDS TR antenna; IDS declines any responsibility for

damage caused to the system due to erroneous connections.