User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N doc: MN/2009/028 - Rev. 1.1
DETECTOR DUO SYSTEM – User manual
55 / 74
All information contained in this document is property of IDS. All rights reserved
• Longitudinal;
• 2 in the Coord value field;
• 2 in the Coord. Step field.
Once the scan is finished, the coordinate of
the L value is automatically positioned on the
value 4.
!
B E CA REFUL
The Antenna Box may only be moved in one direction. It may
only be pulled or pushed in the direction of increasing scanning
coordinates .
• Scan Offset (m) : each radar scan is characterised by an
initial L and/or T co-ordinate Therefore, once you have
inserted the starting point co-ordinate for the investigation
(“ coord. value ”) as a function of the type of scan, the
other reference co-ordinate must be defined in the “ Scan
Offset (m) ” field. The following option must then be
selected:
• On L/T coordinate ” selection
Here, you have to manually measure the value of
the co-ordinate corresponding to the centerpoint of
the antenna box with respect to the reference
system selected previously, and insert it into the
active field.
For example, if you have to perform a transversal
scan starting from the co-ordinate T=2 and L=2,
you must set the type of scan to Transversal and
then set the actual value of the T co-ordinate (e.g. 2
m) in the “ Coordinate (m) ” field. Next, activate the
“ L coordinate ” in the “ Scan Offset (m) ” area,
setting it to 2 in this case. The scan can now be
performed.