User's Manual

APPENDIX A. Disclaimer
IDS GeoRadar s.r.l. MN/2016/011 Rev 1.0 Draft 23/ 36
Mounting the GPS pole support (optional) 4.7
An optional GPS pole support can easily be mounted at the left rear side of
the main frame (Fig. 4.16). To do this, just slide the metal part of the
support from left to right of the frame.
Fig. 4.16 –Mounting the GPS pole support
GPS requirements 5
As the Stream-C system can be operated with a GNSS to position the scans
in real time without the need of creating a grid, the operator should
consider the following requirements relating to the positioning device:
1. Dual frequency (L1+L2);
2. Positioning update greater than 5 Hz;
3. RTK: connection to a base station via radio link (UHF or
GSM) or connection to a Continuously Operating Reference
Station (CORS) via internet;
4. NMEA output;
5. Serial cable (RS232) is required, alternatively the GPS can
be connected to the laptop via Bluetooth.
Maintenance plan 6
Cleaning Information 6.1
Before cleaning any external parts of the apparatus, make sure that all
cables have been disconnected, including the power supply cable. If a damp
cloth is used, make sure it is not too wet, to avoid any damage to the
electrical components of the equipment. Wait until the equipment is totally
dry before reconnecting the cables.
The Stream-C should be cleaned periodically using a damp cloth.
Do not use solvents or abrasive detergents.
Do not apply liquid directly to the electrical contacts of the various
connectors. If a specific spray is used to clean the PC TFT monitor, make
sure it is not flammable; in any case, do not spray it directly on the screen,
instead, spray it onto the cleaning cloth.