User's Manual

APPENDIX A. Disclaimer
IDS GeoRadar s.r.l. MN/2016/011 Rev 1.0 Draft 18/ 36
Fig. 4.3 – Laptop support inclination regulation
Connect the antenna 4.2
To connect the antenna with the main body of the system, pull up the front
of the frame (Fig. 4.4), and lay it gently on top of the antenna, paying
attention not to damage any part of the connectors. Then, connect the
cables to the connectors on top of the antenna and the DAD, and lock the
hooks to the up/down system of the frame, as specified below.
possible hazardous situation
In performing this operating pay attention not to pinch fingers between the
main body of Stream-C, and the antenna body.
Fig. 4.4 – Raising the frame to connect the antenna
In particular, follow these steps:
1. Connect the battery cable between the frame and the DAD (),
2. Connect the LAN cable (),
3. Connect the antenna cable between the DAD and the antenna (),
4. Connect the wheel cable (),
5. Connect the second power cable between the frame and the
antenna,
6. Connect the quick release to the four u-shaped hooks on top of the
antenna ().