User's Manual

IDS Ingegneria Dei Sistemi S.p.A. Protocol: MN/2009/061 - Rev. 1.1

“ALADDIN” STRUCTURE KIT User

Manual

4.3.2 “Manual” Mode

Steps 1-4: Follow the same procedure described for "Automatic"

mode above.

Step 5: Acquisition starts when you press the START button,

independently of the position of the first horizontal line encountered.

Step 6A (Standard System): Insertion of User Markers during

scanning is performed by rapidly pressing the START button.

Step 6B (US System): Insertion of User Markers during scanning is

performed by rapidly releasing and pressing again the START

button.

Step 7A (Standard System): The scan is STOPPED by keeping the

START button pressed

Step 7B (US System): The scan is STOPPED by releasing the START

button

NOTE!

The system keeps control of data quality (Tolerance

) in both

Automatic and Manual mode. In fact, if this tolerance is

respected, a confirmation acoustic signal is activated; if the

tolerance exceeds the pre-

set percentage during the scan,

an error acoustic signal is heard, the scan isn't saved and you

have to repeat it.

4.3.3 “Manual (no check)” Mode

Step 1-7: In this case the user must use the PSG carpet –Pad Survey

Guide Guide (Fig. 4-6) with the slide applied under the frame (see Par.

3.2.3).