User's Manual

IDS Ingegneria Dei Sistemi S.p.A. Protocol: MN/2009/061 - Rev. 1.1

“ALADDIN” STRUCTURE KIT User

Manual

Fig. 3-3 – Removing the DAD and the antenna trolley

 Remove the bipolar antenna, pushing the lever towards the foam

support then lift the antenna out rotating it slightly (see the

direction of the red arrow in Fig. 3-4); when you have to replace

the antenna in the case, be careful that the white pegs on the side

of the antenna are blocked into the two holes inside the case

(indicated with the red circle).

Fig. 3-4 – Removing the bipolar antenna

 Open the bottom section (Fig. 3-4 and Fig. 3-5); this is the PC

storage area; if a PC has not been supplied with your order, you

can store your own PC here using the pre-cut foam to model a

suitably shaped space (Fig. 3-5). The maximum space available

for storing a PC is 34cm x 27cm x 5cm.

How to

remove the

antenna