User's Manual

16
1.4 Display and Buttons
Control panel of Printer consists of 2 lines LCD and 2 buttons. The 2 buttons have the functions
as shown in the Figure 8.
Figure 8 SMART-51 Display and Buttons
The status of SMART-51 is ‘Initializing’ when boot up. It is changed to ‘System Ready’ if the
printer is fine. It is change to ‘Printing’ when the printer is working. In case of sensing an error,
it is changed to ‘Error’ status. Whenever the top cover is opened, the operation is stopped and
the status is ‘Top Cover Open’.
The functions of the button under each status are as below table.
Status
Left Button
Right Button
Initializing
N/A
N/A
System Ready
Ribbon Type/Balance
Sleep
Laminating Film Type/ Balance
Initializing
User Printed Counts
Network IP Address
Subnet
Gateway
Network MAC Address
Pulling out the card
Printing
N/A
N/A
Error
Retry
Cancel
Top Cover Open
Move to backward a card
Move to forward a card
Cleaning Mode (when both buttons are pushed)
Left
Button
Right
Button
Two Line LCD