User Guide

Please read the instruction manual carefully before operation
(1)Step 1,check the accessory list
Microphone
Microphone
Desktop Stand
Desktop Stand
Shock Mount
POP Filter
POP Filter Shock Mount
USB Cable
USB Cable
USB CONDENSER MICROPHONE
-33±2dB (1.5V, 680KΩ；0dB-1V/Pa, 1KHz)
100Hz-20000Hz
<680Ω
>68dB
110dB
96KHZ/24Bit
cardioidPolar Pattern
Sensitivity
Frequency Response
Sampling Rate
Max SPL
S/N Ratio
Impedance
1. Product Diagram
2. Installation
3. Specifications
4.General operation cont
To manually adjust your input level via your computer’s
system preferences, use the following instructions relevant
to your device platform/operating system.
Adjusting the input level on a Mac OS computer:
1. Click on the Apple symbol at the top left of your screen,
and select System Preferences.
Accessing Mac OS System Preferences
Product Model: M2
Place the desktop stand on the table and loosen the nut to adjust
the deployment angle of the desktop stand.
1
Pinch the handle of the shock mount and insert the microphone into
the shock mount.
2
Install the assembled microphone and shock mount on the desktop
stand.
3
Install the Pop filter on the desktop stand,and adjust the position.
4
Connect the microphone to the computer and other devices with a
USB cable.
5
(2) Please follow the steps below to install the microphone and stand.
Handle of
Shock mount
140mm
55mm
Earphone Jack
Volume
3
2
4
1
Connect the microphone to the computer
Compatible with IOS
and WIN system
The LOGO side is the
correct recording side
-6--5--4--3--2--1-