Instruction Manual

61
• Cumulative Operation Time Selection (n087)
Cumulative operation time setting.
Inverter operating time set with parameter n087 is accumulated by the unit of 10H.
Accumulation starts from the time set with parameter n088.
• Installed Braking Resistor Overheating protection Selection (n165) Set
“0” when braking resistor is not connected.
Setting Description
0
Inverter power-on time
(Counts the elapsed time that there is an inverter output)
1
Inverter running time
(Counts the elapsed time that there is an inverter output.)
Parameter No. Name Unit Setting Range
Initial
Setting
n088 Cumulative operation 1 = 10H 0 to 6550 (65500H) 0 (H)
Setting Description
0 Overheating protection is not provided
1 Overheating protection is provided