Instruction Manual

Open the front cover and verify that the strip length is 0.22 in. (5.5mm)

• Wiring Inspection

After completing wiring, check the following:

• Wiring is properly connected.

• Wire clippings or screws are not left inside the unit.

• Screws are securely tightened.

• Bare wires in the terminal do not come in contact with other terminals.

NOTE

If the FWD (REV) run command is given during the operation reference selec-

tion (n003=1) from the control circuit terminal, the motor will start automatically

after the main circuit input power supply is turned ON.