Manual
31
ISMATEC SA/BVP Standard/12.03.07/CB/GP
Kolbenpumpenköpfe
Die Kolbenpumpenköpfe sind nach
jedem Einsatz gründlich durchzuspülen
- besonders beim Pumpen von salz-,
eiweiß- oder partikelhaltigen Medien.
Es dürfen keine Medien mit Partikeln
größer als 0.8 mm gepumpt werden.
Piston pump-heads
After use, the piston pump-heads
require thorough flushing
- especially after pumping media contai-
ning salt, protein or particles.
Do not pump media containing particles
that exceed a diameter of 0.8 mm.
Têtes à pistons
Les têtes de pompe à pistons doivent
être soigneusement rincées après
chaque utilisation.
Particulièrement après le pompage de
liquides contenant du sel, des protéines
ou des particules.
Ne pas pomper de liquides contenant des
particules plus grandes que
0.8 mm.
Typ/Type PTFE QP Q0 QP Q1 QP Q2 QP Q3
Kanäle/Channles/Canaux 1 1 1 1 1
Pumpensystem
Pump system/Système de pompe
PTFE Schlauch
PTFE Tubing/PTFE Tubes
PTFE Schlauch
PTFE Tubing/PTFE Tubes
PTFE Schlauch
PTFE Tubing/PTFE Tubes
PTFE Schlauch
PTFE Tubing/PTFE Tubes
PTFE Schlauch
PTFE Tubing/PTFE Tubes
min
-1
rpm t/min 2.4 240 2.4 240 2.4 240 2.4 240 2.4 240
Schlauch
Tubing/
Tubes
oder/or/ou
Winkel
Angle/Angle
Fließraten
Flow rates/Débits
ml/min
Fließraten
Flow rates/Débits
ml/min
Fließraten
Flow rates/Débits
ml/min
Fließraten
Flow rates/Débits
ml/min
Fließraten
Flow rates/Débits
ml/min
min max min max min max min max min max
PTFE I.D. 2.0 0.15 15
PTFE I.D. 4.0 0.45 45
Low Flow
High Flow
Winkel
Angle
Angle
1 0.019 1.9 0.077 7.7 0.17 17 0.31 31
2 0.038 3.8 0.15 15 0.35 35 0.61 61
3 0.058 5.8 0.23 23 0.52 52 0.92 92
4 0.077 7.7 0.31 31 0.69 69 1.2 120
5 0.096 9.6 0.38 38 0.86 86 1.5 150
6 0.12 12 0.46 46 1.0 100 1.8 180
7 0.13 13 0.54 54 1.2 120 2.2 220
8 0.15 15 0.61 61 1.4 140 2.5 250
9 0.17 17 0.69 69 1.6 160 2.8 280
0 0.19 19 0.77 77 1.7 170 3.1 310