User Manual

13
around a pen). Remove the mounting plate
from the wall.
12. Line up the iDevices
®
Thermostat mounting
plate on the wall in the desired location.
Check that it is level and the wires are in
a position to t through the hole on the
mounting plate. Use a pencil to mark anchor
locations on the wall.
13. Set the mounting plate aside. Drill two holes
(3/16” diameter) at the locations you
have marked.
14. Install the provided anchors into the wall, line
up the mounting plate to the holes and install
with the provided screws.
15. Head to the Wiring Conguration section,
starting on page 18, to nd the conguration
that is closest to your old thermostat
and note which system you have for later
reference.