Installation Manual

14 15
based on the information you gathered in
the chart on pages 11-12, photos you took
earlier and wiring conguration you noted
for step 15.
17. To prevent electrical shorts and damage to
your iDevices
®
Thermostat or home, ensure
all of the wire connections are secure
and there are no bare wires in contact with
another. Insulate bare wires with electrical
tape as necessary. Push any excess wire back
into the wall cavity.
18. Attach your iDevices
®
Thermostat to the
mounting plate.
19. Turn your power on at the breaker box or
switch that controls your heating/cooling
system.
20. Your iDevices
®
Thermostat will automatically
turn on and display the “Connecting
Thermostat to Network” screen.
Note: The Thermostat will stay in the
connection mode for 30 minutes before
timing out. You can manually enter this mode
from the Settings > Setup > Connect menu.
Connecting To The App And Wi-Fi
®
Network
1. Download and launch the free iDevices
®
Connected app on your mobile device.
2. From the iDevices
®
Connected app, add the
Thermostat by tapping on the menu bar in
the upper right-hand corner.
3. Follow the instructions in the app to
complete the connection process.
Conguring The Thermostat For
Your HVAC System
1. Refer to Thermostat Settings for your system
conguration, starting on page 8.
2. Press the button on your
iDevices
®
Thermostat.
3. Use the buttons to scroll to ‘Setup’
and press the button to select.
4. Use the buttons to scroll to ‘HVAC TYPE’
and press the button to select.
5. Using the buttons to scroll and the
button to select, set the Stage and Type for
your system conguration (A through D).
6. If you have a heat pump, set O/B Type to
what you recorded earlier.
7. Your iDevices
®
Thermostat is now congured.
Conguring the HUM Relay
The Terminal labeled “HUM” serves as
multipurpose relay to allow for Humidication,