User Manual
Table of Contents In the Box ������������������������������������������������������������������������������3 System Requirements �����������������������������������������������������������3 Getting Started ���������������������������������������������������������������������3 Unit Setup �����������������������������������������������������������������������������3 iDevices® Connected App ���������������������������������������������������4 Problem Solving ����������������������������������������������������
In the Box Inside your Socket box, you will find: • 1 iDevices® Socket • 1 QuickStart Guide System Requirements • iPhone® 4S and later • iPad® 3rd generation and later • iPad mini™ and later • iPod touch® 5th generation and later • HomeKit™ requires an iPhone, iPad, or iPod touch with iOS 8.1 or later • iDevices® Connected app version 2.0 or higher • Wi-Fi® 2.4GHz 802.
• Screw in your Socket and turn on the power to the socket • Please note that the power to the Socket must always be on • The Socket will blink blue indicating it is ready to be set up on the network • Blue blinking will slow down if the unit is not set up • To reinitiate set up, hold the button down for 3 seconds • Unit will blink blue faster, indicating it is ready to set up • A bulb can be screwed in at any time. By default the Socket sets the bulb to full brightness.
• Tap on the Socket you’d like to configure • Confirm your home network and personalize the name of your Socket • Once set up process is complete, unit will identify itself • Enter 8 digit pin previously noted, located on both QuickStart Guide and back of unit Problem Solving The following information covers some of the most common troubleshooting issues with the iDevices® Socket.
Night Light Color Codes The iDevices® Socket uses the nightlight LEDs to indicate the status or mode of the Socket during and after initial set up. Typically the LEDs are only used when there is no other means to inform the user of the status of the Socket. The following table summarizes the Socket modes and LED status states.
Regulations Product Information: Manufacturer: iDevices® LLC Model: IDEV0002 FCC ID: 2ABDJ-SOCKET IC: 11569A-SOCKET FCC Compliance Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement Caution: This transmitter must be installed to provide a separation distance of at least 20 cm from all persons. Canada – Industry Canada (IC) This device complies with Industry Canada license-exempt RSS Standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
References Requires the iDevices® Connected app. For warranty information please visit iDevicesinc.com/Warranty Apple, the Apple logo, iPhone, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. App store is a service mark of Apple Inc. HomeKit is a trademark of Apple Inc.
