Integration Manual

uTrust 5501 F HF – OEM Integration Manual

Version: 1.1 Page 4 of 5

1 Scope of the document

This manual provides information for OEMs that integrate the uTrust 5501 F HF into their own

products.

2 Identiv uTrust 5501 F HF module

Identiv uTrust 5501 F HF is an USB based contactless card reader module. The reader

connects to host via USB 2.0 Full speed interface. It supports ISO14443 and ISO15693 cards

in HF mode. The information in this manual applies to the device model number listed below

along with its FCC ID and ISED ID:

Part Number Product Name FCC ID ISED ID

905567-3 uTrust 5501 F HF MBPUT5501F-01HF 7485A-5501F01HF

3 Host Communication Interface

Host communication is through the 1x5 header marked USB host.

Pinouts for USB host connector is as below:

PIN #

Signal

1 Vbus

3 D+

4 GND

5 Shield

The mating connector/receptacle for the header is TE Connectivity 440129-5

4 Integration Guidelines

1. This module is limited to OEM installation only.

2. Module complies with FCC Part 15.225, FCC Part 15.209, FCC Part 15.207 and RSS-

210.

3. End Product Labeling: When the module is installed in host device, the FCC ID label must

be visible through a window on the final device or it must be visible when an access

panel, door or cover is easily removed. If not, a second label must be placed on the

outside of the final device that contains the following text:

“Contains FCC ID: MBPUT5501F-01HF”. The FCC ID can be used only when all FCC

compliance requirements are met.

For ISED the second label should include “Contains IC: 7485A-5501F01HF”. The ISED

ID can be used only when all other ISED compliance requirements are met.

4. Installation: The module must be installed such that 10 cm distance is maintained

between the integrated antenna and users.

5. The end user manual shall include all required regulatory information/warning as shown in

this manual.

6. There are no special testing modes for the module. When the module is powered it

automatically start scanning at 13.56 MHz (ASK) looking for tags. When a tag that

operates at same frequency and technology responds, the module locks onto it; the

module would not change to other frequency or technology until the tag leaves the field or

stops responding.