Users Manual

Note:

Some devices, such as iPhone, will connect immediately after pairing so the LED

will ON. Other devices, such as notebook, may ask you if you wish to connect

and LED will go off after pairing until a connection is established.

Although the BTR-1600HDN can only play music from one device at a time, it is

capable of being paired to up to 8 devices.

You can play the music now. Just play music on your device as you normally would and

the sound will come out from your stereo system.

Note: the effective range of BTR-1600HDN is 66 feet (20M) (light of sight). If you

hold and wear the Smartphone or tablet and cover the Bluetooth antenna, the

distance will be shorter.

Reconnecting your device

If you move out of range or turn off the Bluetooth feature on you iPad/iPhone/iPod

touch or Smartphone,BTR-1600HDN will be disconnected from your device. To

reconnect, simply open the Bluetooth manager and tap on the “BTR-1600HDN”, then

you do not need to input PIN again, the connection will be done automatically.

Adding a new phone or tablet：

If you want to switch from one device to another, please follow these steps

1. End the existing Bluetooth connection with connected device.

2. The BTR-1600HDN can now be connected with another device such as

iPad/iPod/iPhone or Smartphone or tablet.

3. Follow the section “Pairing the BTR-1600HDN” to connect a new device.

Out of range or lost signal:

When the paired phone or device away from receiver (66 feet) or there is

something blocking the Bluetooth signal. The LED light will go off, it means the

connection between device and BTR-1600HDN is lost. To avoid a lost connection:

1. Move the music device back into range ( within 66 feet), and make sure there’s a

clear line of sight and there are no obstructions between BTR-1600HDN and

device.

2. Within 10 mins, the connection will automatically be reestablished and LED will

turn on

3. If the connection is lost for more than 30 seconds, you need to reconnect the

device and BTR-1600HDN again. Please follow the “Reconnect Your Device”

section.