User's Manual

Page 4 of 23
i-Q 310 ISO 18000-7 Transponder Series
Safety Precautions
Important Safety Notes
The system described in this manual is for exclusive operation by trained employees. Only qualified personnel that know the potential
dangers involved should perform the installation, settings, maintenance and repair of the units used.
On account of high operating temperature of 80°C (+176°F) care must be taken, if the tags are heated. To avoid burn wait a while until the
tags have cooled down or use gloves. At temperatures below 0°C (+32°F) tags can be iced. In this case, wait a while until tags are warmed
up or use gloves.
The models i-Q310 SET, i-Q310 CST, i-Q310 ATR, i-Q310 LPT and i-Q310 DRT contain replaceable battery. Due to UL safety clauses this
battery must be replaced only by skilled personnel. See also chapter Battery Replacement Procedure.
All tags contain a battery. That is the reason for the following instructions:
CAUTION
CAUTIONCAUTION
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
RISK OF EXPLOSION IF BATTERY IS REPLACEDRISK OF EXPLOSION IF BATTERY IS REPLACED
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
BY AN INCORRECT TYPE.BY AN INCORRECT TYPE.
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
DISPOSE OF USED BATTERIES ACCORDINGDISPOSE OF USED BATTERIES ACCORDING
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
TO THE INSTRUCTIONSTO THE INSTRUCTIONS
TO THE INSTRUCTIONS
Operational Safety
The correct and safe use of these systems assumes that operating and service personnel follow the safety measures described in the manual
alongside the generally acceptable safety procedures.
If there is a possibility that safe operation cannot be guaranteed the system must be switched off and secured against accidental use. Then
the service unit responsible must be informed.
Electrostatic Discharge
This product contains components that are sensitive to electrostatic discharges. Please observe the special instructions for
their protection. Incorrect handling can damage the unit and cause the invalidation of the warranty.
Safety Documents
This ILR system was designed, tested and supplied in perfect condition according to document testreport EN60950.
Condensation/Change of Temperature
Moving the systems from a cold to a warm environment could lead to dangerous situations due to condensation. Therefore it must be
ensured that the system can adjust itself to the warmer temperature.
Spare Parts
We recommend that only original products, spare and replacement parts authorized by IDENTEC SOLUTIONS be used for installation, service
and repair. Otherwise IDENTEC SOLUTIONS does not accept any responsibility for materials used, work carried out or possible consequences.