User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -9-
2.3 LED Displays
Status LEDs:
POWER: Lights up as soon as power is applied to the i-PORT
RUN: Blinks (every 2 seconds) as soon as the i-PORT has booted (approx. 30 seconds)
HOST: Lights up as soon as a host is connected to the i-PORT
ERROR: Lights up as soon as an error occurs (see section: Troubleshooting)
COM LEDs:
RX: Lights up when the i-PORT receives data on serial interface
TX: Lights up when the i-PORT sends data on serial interface
INPUT LEDs:
1-4: Light up when Inputs 1-4 are set (Connection to Ground)
ANTENNA LEDs:
1-4: Light up when there is activity at corresponding Antennas 1-4
Green: Antenna is sending
Red: Antenna is receiving
W: Lights up when there is activity at the Wake-up Antenna
OUTPUT LEDs:
1-4: Light up when the corresponding Outputs 1-4 are set