User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -8-
2.2 Physical Description
211
238,7
21,9
180
20,590
5
201
a
The amount of space required to mount the i-PORT is 200 x 250 x 60 mm (B x H x W). The i-PORT weighs
approx. 2 kg. A socket wrench (size 3) is required to open the i-PORT.
Use the rubber grommet with hole to feed cables through the housing to the outside (cable diameter 4.75
mm to 6 mm); seal the unused feed-through with the blind plugs. These feed-through are intended for
RG58 (antenna), Ethernet or serial cables. For power supply, use the PG fitting [screw joint]. If plugs [jacks,
connectors] do not fit through the grommet (i.e. Ethernet), you may cut through the grommet (Note:
impermeability!).
Enclosure rating IP64 (total protection from water sprayed from all directions) is thus achieved. If greater
enclosure rating is required, the i-PORT must be placed in an additional housing.