User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -36-
Key Value Description
min max default unit type
Antenna Settings
Ant1Enable 0 1 1 bool Enable or disable this antenna
0...disable antenna
1...enable antenna
Ant1ScanEnable 0 1 1 bool 1...antenna is a sending antenna
Ant1TxPowerQ -30 6 -6 dBm int TX Power for i-Qx
Ant1TxPowerD -30 30 20 dBm int TX Power for i-Dx
Note: This command has no effect in this
version!
Ant1RxThreshold -100 -20 -100 dBm int Receive Threshold
Ant1HighSens 0 1 0 bool 0...antenna low sensitive
1...antenna high sensitive
Ant1CableLoss -20 20 0 dB int Calibration factor to cal. antenna and cable
Ant1SynchGroup 0 4 0 enu
m
Ant2Enable 0 1 0 bool Enable or disable this antenna
0...disable antenna
1...enable antenna
Ant2ScanEnable 0 1 1 bool 1...antenna is a sending antenna
Ant2TxPowerQ -30 6 -6 dBm int TX Power for i-Qx
Ant2TxPowerD -30 30 20 dBm int TX Power for i-Dx
Note: This command has no effect in this
version!
Ant2RxThreshold -100 -20 -100 dBm int Receive Threshold
Ant2HighSens 0 1 0 bool 0...antenna low sensitive
1...antenna high sensitive
Ant2CableLoss -20 20 0 dB int Calibration factor to cal. antenna and cable
Ant2SynchGroup 0 4 0 enu
m
Ant3Enable 0 1 0 bool Enable or disable this antenna
0...disable antenna
1...enable antenna
Ant3ScanEnable 0 1 1 bool 1...antenna is a sending antenna
Ant3TxPowerQ -30 6 -6 dBm int TX Power for i-Qx
Ant3TxPowerD -30 30 20 dBm int TX Power for i-Dx
Note: This command has no effect in this
version!
Ant3RxThreshold -100 -20 -100 dBm int Receive Threshold
Ant3HighSens 0 1 0 bool 0...antenna low sensitive
1...antenna high sensitive
Ant3CableLoss -20 20 0 dB int Calibration factor to cal. antenna and cable
Ant3SynchGroup 0 4 0 enu
m
Ant4Enable 0 1 0 bool Enable or disable this antenna
0...disable antenna
1...enable antenna
Ant4ScanEnable 0 1 1 bool 1...antenna is a sending antenna
Ant4TxPowerQ -30 6 -6 dBm int TX Power for i-Qx
Ant4TxPowerD -30 30 20 dBm int TX Power for i-Dx
Note: This command has no effect in this
version!
Ant4RxThreshold -100 -20 -100 dBm int Receive Threshold
Ant4HighSens 0 1 0 bool 0...antenna low sensitive
1...antenna high sensitive
Ant4CableLoss -20 20 0 dB int Calibration factor to cal. antenna and cable
Ant4SynchGroup 0 4 0 enu