User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -34-
Appendix A – Configuration Parameters
i-PORT Configuration Descriptions
Key Value Description
min max default unit type
i-PORT General
IportType 0 1 0 enum 0...Host
1...Client
IportMainID 0 65535 0 uint Main identification number of the i-PORT
IportSubID 0 65535 0 uint Sub identification number of the i-PORT
IportSerlDevice 0 3 0 enum Selects the device connected to serial interface
0...no device
1...GPS device
2...Modem
3...Serial Host ( Comm. Protocol serial )
IportLongitude -180. 180. 0. deg float Longitude co-ordinates (east) of the i-Port
IPortLatitude -90. 90. 0. deg float Latitude co-ordinates (north) of the i-Port
Host Connection
HostIpAddr 0.0.0.0 255.255.
255.255
0.0.0.0 IP Defines the IP address of the host computer
HostPort 0 65535 6780 uint Port number of the host computer
HostTimeOut 0 32767 2 sec uint Timeout for acknowledge from host –> send it
again
HostSyncInterval 0 32767 0 sec uint Time interval to synchronise iPort clock with
host clock 0...never
HostSendInterval 0 32767 2 sec uint Time interval to send messages (only if
available) to host
OR
Send Interval of Events
HostListSize 0 32767 0 uint Minimum list size to send whole message list to
host
0...send interval controlled only by
HostSendInterval
Debug Configuration
DebugHostMirror 0 1 1 bool 0...no debug output
1...”mirrors” the communication to host to
debug port
DebugTagList 0 32767 0 sec uint Debug output cycle time
DebugNewTag 0 1 0 bool Sends all new entries of tags in the list to
debug port
DebugScanTag 0 1 1 bool Sends all tags from the last scan to debug port
Time Server
TimeServerType 0 2 0 uint 0…disable Time server
1…SNTP
2…Daytime
TimeServerPriIP 0.0.0.0 255.255.
255.255
0.0.0.0 IP
TimeServerSecIP 0.0.0.0 255.255.
255.255
0.0.0.0 IP
TimeSyncInterval 1 65535 1 uint Time interval to synchronise iPort clock with
server