User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -3-
Radio Frequency Compliance Statement
IDENTEC SOLUTIONS AG is the responsible party for the compliance of the following devices:
MODEL: i-PORT III i-CARD i-D2 TAGS i-Qxx TAGS
FCC ID: OO4-IPORT3-NAE
O2E-ILR-IPORT3
O2E-ICARD-NA
OO4-ILR-ICARD3
OO4-ILR-ID2
O2E-ILR-ID2NA
OO4-ILR-IQ32T
OO4-ILR-IQR
CANADA: 35381032231 3538A12112 35381021756A
35381021825
The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by
IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by IDENTEC
SOLUTIONS or unauthorized changes to approved products, may void the compliance of these products and
may result in the loss of the user(s) authority to operate the equipment.
Operation is subject to the following conditions: (1) these devices may not cause harmful interference, and (2)
these devices must accept any interference, including interference that may cause undesired operation of the
device.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Important Note
To comply with FCC radio frequency exposure compliance requirements, this device must be installed by an
IDENTEC SOLUTIONS certified technician. When installing antennas, a 20 centimeter passing distance must be
maintained from any body part of the user or nearby persons and the antenna.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation