User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -29-
7.0 Technical Specificatons
ILR
®
Parameters
Compatibility ILR
®
i-Q Tags
ILR
®
i-Q Tag
Read range (adjustable) 100m (300 ft)
Write range (adjustable) 100m (300 ft)
Max. response time (single
tag)
< 150 ms
Read rate (ID only) 100 tags/s
Read rate – 128 bit data 35 tags/s
Multi-tag-handling
(simultaneous)
Up to 2,000 tags
RF Interface
Frequency 868 MHz Band
Certification
RF rate of transmission
FCC, part 15 (US)
EN 330 220 (EU)
i-Q 115.2 kbit/s, 115.2 kbit/s (Rx)
Number of antennas 5 (4 read/write + 1 wakeup)
Antenna transmitters 5
Output power: up to 3 dBm — adjustable
Antenna receivers 4
Sensitivity: up to -90 dBm — adjustable
Antenna control Independent antennas, simultaneous operation (receive)
User Interface
Ethernet interface 10 Mbit/s / 100 Mbit/s
Protocols TCP/IP: FTP, HTTP, Debug Port 7090, Communication Port 7070
UDP: SNMP, SNTP, Synchronization Port 7080
Serial interface RS 232
Rate of transmission, serial 1.2 to 115.2 kbit/s
Input control 4 digital inputs for process synchronization
Active when grounded, R
max=560 Ohm
Output control 4 relay outputs for process control
max. breaking capacity: 30W (DC); 62.5VA (AC)
max. contact load: 1A at 30VDC, 0.5A at 125VAC
Status signals 19 status LEDs (for service and installation)
CPU
Operating system RTOS (Real Time Operating System) Thread X
Program memory 2 MB Flash
8 MB DRAM
Data memory 128 KB SRAM
Configuration memory 8 KB EEPROM
Time base Battery-backed Real Time Clock (RTC)