User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -28-
6.0 Operating Restrictions
6.1 Triggered Operation, FCC 15.231 (a)
If the i-PORT III will be used for triggered operation according to FCC 47 CFR §15.231 (a) the
following restrictions have to be obeyed:
- Maximum radiated power must not exceed 3dBm (2mW EIRP), including all cable losses
and antenna gain. To calculate this radiated power from the settings of the i-PORT please
see paragraph 4.4 above.
- Length of transmission has to be limited to 5 seconds. This can safely be done by reading
no more than 4kB of data from a tag.
Please note that this are functions of both the driving software and the setup of the device. In
order to avoid any violations of the FCC rules the responsible System Integrator and his trained
installation personnel has to implement this in the application software and use the password
mechanism built into the i-PORT. This will prevent the user to adjust any settings which are not
allowed.
This system is only authorized for professional installation.
Please note that the output power and scan pause can be set in the configuration menu. In order
to avoid any violations of the FCC rules the responsible System Integrator and his trained
installation personnel has to use the password mechanism built into the i-PORT. This will prevent
the user to adjust any settings which are not allowed.