User's Manual

i-PORT III User’s Guide
Document ID: UG-i-PORT III NAE -18-
Project User Assigned
PASSWORD SETTINGS:
Disable Password Yes/No
Change Password Change Password
CUSTOM APPLICATION SETTINGS:
Enable Custom Application Yes/No
NETWORK INTERFACE PARAMETERS:
DHCP Enabled Yes/No
IP Address Static IP (if DHCP is Disabled)
Subnet Mask Subnet mask
Gateway Gateway IP if needed
Com1 PPP IP Necessary for Modem
Com1 PPP Peer IP Necessary for Modem
HARDWARE PARAMETERS:
Baud Rate Data transmission 1.2 to 115.2 kbit/s
Boot Delay Amount of time to access the Boot menu
After the changes have been made and confirmed, the i-PORT will boot up and go into the designated
mode. You can write down the new IP address in the designated spot inside the i-PORT door.