User's Manual

i-PORT F310
Page 13 of 17
4 Initial Operation
4.1 Checking the Installation
After completing the installation the operation must be systematically checked.
The installation check can be divided into three sections:
• Visual test
• Basic operational check
• Detailed operational check
If the basic check of the operational behavior is to be carried out using a (portable) PC a final check
via the intended user control system should also be carried out.
4.2 Configuration
4.2.1 Tools Needed
4.3 Configuration of the Ethernet Interface
Tools needed
• PC with working Ethernet NIC running MS Windows for configuration software
• Software “Device Discovery Utility”
• Crossover Ethernet cable
• Power supply (24 VDC) for the i-PORT
• Network settings from your network administrator
Prepare the PC
• Disconnect the PC from the network
• Set the Ethernet connection of the PC to DHCP (described below)
• Switch off the proxy settings of the standard web browser
After finishing the configuration of all i-PORTs restore the previous settings of the PC.