User's Manual

i-Q350LX GPS -SAT

USER MANUAL

VISIBILITY DELIVERED. PAGE 3 OF 31

Radio Frequency Compliance Statement

IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices:

MODEL:

i-Q350LX GPS -SAT

Region/Country

Organization

Marking

EUROPE:

USA:

FCC

FCC ID OO4-ILR-IQ350SAT

Contains FCC ID: L2V-STX3

Canada:

Industry Canada

IC:3538A-IQ350SAT

The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by

IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by IDENTEC

SOLUTIONS, or unauthorized changes to approved products, may void the compliance of these products and may

result in the loss of the user(s) authority to operate the equipment.

European Notification according R&TTE Directive

This equipment complies to Art. 6.4 of R&TTE Directive (2006/95/EU, 2004/108/EC, 1999/5/EC). It is tested for

compliance with the following standards: EN 300 220-1, ETSI EN 300 220-2, ETSI EN 301 489-1, ETSI EN 301

489-3, EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011

USA Notification

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

operation.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/ TV technician for help.