User's Manual

i-Q350L RTLS AS & i-Q350L RTLS AH
USER MANUAL
VISIBILITY DELIVERED. PAGE 6 OF 28
Safety Instructions
The system described in this manual is for exclusive operation of trained employees. Only qualified
personnel that have knowledge of the potential dangers involved should perform the installation,
settings, maintenance and repair of the units used.
Operational Safety
The correct and safe use of these systems assumes that operating and service personnel follow the
safety measures described in the manual alongside the generally acceptable safety procedures.
If there is a possibility that safe operations cannot be guaranteed, the system must be switched off,
secured against accidental use and the service unit responsible immediately informed.
Safety Documents
The i-Q350L RTLS AS/AH was designed, tested and supplied in perfect condition according to
document IEC348 Safety Requirements for Electronic Units of Class 1.
Condensate / Change of Temperature
To avoid condensation in the system, the unit must be allowed to slowly adjust itself to warmer
temperatures after removal from cold and cool environments.
Do not open the housing
There is no need to open the housing during setup. Configuration is done with built in interface
wirelessly. The only exception is for battery exchange.
Battery Inside
All system Transponders contain a battery; therefore, the following warning should be heeded;
Warning
Fire, explosion and burn hazard
Risk of explosion if battery is replaced by an incorrect type
Do not recharge, short circuit, crush, disassemble, heat above 100 °C (212 °F)
Do not incinerate, or expose contents to water
Spare Parts
We recommend that only personnel, original products, spare and replacement parts authorized by
IDENTEC SOLUTIONS be used for installation, service and repair. IDENTEC SOLUTIONS does not
accept any responsibility for materials used, work carried out or possible consequences from
unauthorized third party vendors.