User's Manual

i-Q350L RTLS AS & i-Q350L RTLS AH
USER MANUAL
VISIBILITY DELIVERED. PAGE 20 OF 28
The Transponder contains a motion sensor that is interrogated every 100 ms. If motion is detected,
the movement counter is increased. If no motion is detected the movement counter is decreased. If
the value of the movement counter reaches the threshold value “Movement On”, the Transponder
can switch its ranging status from “On Stop” to “Default” or vice versa according to the setting
“Ranging Behavior”. If the value of the movement counter drops below the threshold value
“Movement Off” the ranging behavior is switched again.
So by adjusting these 5 parameters of the movement counter, short-term influences can be
eliminated.
Classic Use Cases
Behavior
Top movement Counter
Movement On
Movement Off
Standard
Application dependent
Application
dependent
Application
dependent
Transponder never reports
movement
Top movement Counter >
Movement Off
Movement On >
Top movement
Counter
0
Transponder always report
movement
Top counter > Movement
On
0
Movement Off >
Top counter
ILLEGAL
0
0
0
Tag considered as
“in motion”
Stop Movement Counter
Tag stationary Tag in motion
Movement On
Movement Off
Tag stationary
Increment by 1
Decrement by 2