User's Manual

i-Q350L RTLS AS & i-Q350L RTLS AH
USER MANUAL
VISIBILITY DELIVERED. PAGE 14 OF 28
4. CONFIGURATION OF THE TRANSPONDER
4.1. General
The i-Q350L RTLS AS/AH is not configured directly. It is configured wirelessly using an ILR GEN3
compatible device, e.g. an i-PORT M350 or i-Port-USB-BT
Things to be configured
 Beacon ping rate (It is recommended to set it at more than 20 seconds. In case there are more
than 500 Transponders in the antenna field it is recommended to set it at more than 60 seconds)
 Monitoring data:
- Monitoring interval (15 min to 2 hours, in steps of 1 minute)
- Data to be monitored
Important Note
Do not open the housing! Configuration is done wirelessly.
The Response mode of the i-Q350L RTLS AS/AH offers the following features for configuration:
 Broadcast mode can be configured for simultaneous operation. In this case the Transponder
responds to commands from a reader as well as broadcasting configurable data at a regular
interval.
 Marker technology for locating the Transponder in an inductive loop and measuring travel time
between gates.
 Bursts triggered by a marker field can be configured independent of regular broadcast pings.
 Bursts triggered by the push button can be configured independent of regular broadcast pings.
Tools Needed
 PC running Microsoft Windows, with SensorSMART Tools installed
 Connection to an i-PORT-M350 or i-Port-BT-USB, to communicate with the Transponders