i-Q350L M, Microtag Manual
Microtag Manual Proprietary Notice This document contains confidential information proprietary to IDENTEC SOLUTIONS and may not be used or disclosed to other parties in whole or in part without prior written authorization from IDENTEC SOLUTIONS.
i-Q350L M Radio Frequency Compliance Statement IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices: MODELS: Region/Country EUROPE USA Canada i-Q350L M Organization EC FCC Industry Canada Marking CE FFC ID 004-ILR-IQ350LM IC: 3538A-IQ350LM The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by IDENTEC SOLUTIONS.
Microtag Manual Contents 1 INTRODUCTION............................................................................................................5 1.1 1.2 1.3 1.4 1.5 1.6 PREPARATIONS ....................................................................................................................5 RECOMMENDED PROCEDURE ....................................................................................................5 SCOPE OF THIS DOCUMENT ..........................................................
i-Q350L M 1 1.1 Introduction Preparations This installation manual must be read carefully prior to starting the installation. The described installation works assume that installation materials like cable, antenna and tag holder etc are available. 1.2 Recommended Procedure 1. 2. 3. 4. 5.
Microtag Manual 2 Safety Precautions Important Safety Note The devices described in this manual is for exclusive operation by trained employees. Only qualified personnel that know the potential dangers involved should perform the installation, settings, maintenance and repair of the units used. Operational Safety The correct and safe use of these systems assumes that operating and service personnel follow the safety measures described in the manual alongside the generally acceptable safety procedures.
i-Q350L M Spare Parts We recommend that only original products, spare and replacement parts authorized by IDENTEC SOLUTIONS be used for installation, service and repair. Otherwise IDENTEC SOLUTIONS does not accept any responsibility for materials used, work carried out or possible consequences.
Microtag Manual 3 3.1 Initial Operation Configuration of The Tag Important Note Do not open the housing! Configuration is done using the built-in air interface of the i-Q350L M. Configuration The i-Q350L M is configured according to the specific application by the custom-specific host software. Things to be configured • The ping rate: from 0.5 to 300 seconds in steps of 0.
i-Q350L M 4 4.1 Maintenance General In principle, the ILR system is maintenance-free. When correctly installed it operates for many years without any problems. 4.2 Precautionary Maintenance Regular checking to the system is recommended. Make sure that the housing of the tag has no damage. If there are any damages as holes or cracks, the tags should be replaced and returned to IDENTEC SOLUTIONS immediately. Regular checking of all ports and cables belonging to the system is recommended.
Microtag Manual 5 Technical Data Operating Data Operating frequency ILR-RFID Transmission power Compatibility Standards/Certification 868 MHz (EU) or 920 MHz (NA), further frequencies on request 0.
i-Q350L M Mechanical Data Dimensions Casing Mass Protection class Certifications EMC 56 mm × 30 mm × 14 mm Plastics 40 g IP 65 CE (EN 300 220-1, -3; ETSI EN 301 489-1, -3), FCC Part 15 (US), Industry Canada Page 11 of 11
