User's Manual

Installation and Hardware Manual
Page 4 of 30
USA Notification
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
FCC-NOTICE:
To comply with FCC Part 15 Rules in the United States, the system must be professionally installed to
ensure compliance with the FCC Part 15 certification. It is the responsibility of the operator and
professional installer to ensure that only certified systems are deployed in the United States. The use
of the system in any other combination (such as collocated antennas transmitting the same
information) is expressly forbidden.
INDUSTRY-CANADA-NOTICE:
To comply with Industry Canada Radio Standard Specifications in Canada, the system must be
professionally installed to ensure compliance with Industry Canada Radio Standard Specification
certification. It is the responsibility of the operator and professional installer to ensure that only
certified systems are deployed in Canada. The use of the system in any other combination (such as
collocated antennas transmitting the same information) is expressly forbidden.
CANADA:
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that permitted for
successful communication.
This device has been designed to operate with the antennas mentioned in this document below, and
having a maximum gain of 12 dBi. Antennas not included in this list or having a gain greater than 12
dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
The allowed setting for the transmit power are expressively mentioned in the appropriate chapter.
• ASTRON, Model: DH-8195, elliptical polarized antenna
• WIMO, Model: 900R, linear polarized antenna
• HyperLink Technologies, Model HG903RD-RSP, 1/2-wave whip antenna
For a Class A digital device or peripheral, the instructions furnished the user shall include the following or
similar statement, placed in a prominent location in the text of the manual:
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.