User's Manual

Installation and Hardware Manual
Page 20 of 30
4 Installation
4.1 Mechanical Installation
Mounting Kit
DIN Rail Clamp
Mounting Kit with DIN Rail Clamp
The mounting kit is to be clipped on the back of the i-PORT M350,
there is 5 mm space left for the screws between the mounting kit and the reader.
It is intended to always use the mounting kit. If mounting on a DIN rail is desired, the additional
clamp is mounted on the back side of the mounting kit.
Use the two mounting holes (diameter 4,5 mm) to attach the i-PORT M350 mounting kit to a suitable
mounting surface. Once the mounting kit is fixed, clipped in the i-PORT M350 reader.
Please add to the i-PORT M350 dimensions approximately 70 mm on the antenna side and 40 mm on
the cable side to calculate the required mounting space. The i-PORT M350 weights approx. 310 g in
total including all mounting parts.
Enclosure rating is IP40 without the end cap and IP64 with. If greater enclosure rating is required, the
i-PORT M350 must be placed in an additional protective housing, in this situation the end cap could be
removed.