User's Manual

101053

RF IN Takes a 3.5 inch coax pigtail (part # CAB001) to

connect the ‘RF IN’ port to the ILR-Card RF connector

ANT 1, 2, 3, 4 Independent antenna ports for one to four external

antennas

Note: The address sequencing for the antenna multiplexer is software

controlled.

5 Selector Slide Switches

There are two selector slide switches on the i-PORT. One slide switch

is located on the topside of the LED board, and is used to switch the bar

code connection between RS 232 and RS 485. This switch setting must

comply with the serial interface of the connected device.

The other slide switch is located between the PC Card slots. The setting

options for this switch are RUN and LOAD. This switch must be set to

RUN during operation of the i-PORT. The LOAD position is used to

transfer a compressed binary image file from a Master Image PC Card

to the i-Flash Memory Card. This procedure should only be done by

IDENTEC certified advanced programmers.

6 i-PORT PC Cards

The i-PORT has four PC Card slots on the computer board. The slots

are for the ILR-Card, the i-Flash Memory Card, the ATA Flash Storage

Card, and the User Interface Card.

Note: Each of the four PC Cards described below has its own

designated PCMCIA slot on the Computer Board and is not

interchangeable with the others. Before removing or replacing any of

the PC Cards the power to the i-PORT must be turned off.

Note: All PC Cards used in the i-PORT must be 5 volt.