Reference Manual

ManualsBrandsIdentec Solutions ManualsElectronicsILR-IPORT

113501

Important Note to Installer:

This device requires professional installation by a certified

electronics technician or electrical engineer, following each and all

procedures of the installation manual. This device is only legal to

operate in conjunction with the antenna type approved by FCC and

Industry Canada.

The installer is taking legal responsibility that all steps outlined in

the IDENTEC installation manual have been executed properly,

and that the installed device is complying with FCC Part 15 and the

limits for a ‘Class A Digital Device’, as defined by Industry

Canada.

11.1 Physical Installation

The rugged i-PORT enamel steel enclosure is intended to be wall-

mounted with four adequately sized screws. Before mounting the i-

PORT to the wall the four plastic caps need to be removed from the rear

of the enclosure.

The i-PORT enclosure is rated IP65 (P66?) for protection against water

spray. The enclosure is suitable for industrial installation, but is not

intended to be use in an exterior location. If it is necessary to install the

i-PORT in an exterior location it must have additional shielding against

the weather.

The operational temperature range for the i-PORT is between 32° F and

70° F. If the temperature could vary out of this range additional

precaution must be taken. In the case of cold temperatures a heat

element can be installed in the i-PORT.

11.2 Electrical Installation

Wherever available, a ground wire (Protection Earth) should be

connected to the internal case grounding-stud. This is a

recommendation only and is not essential for i-PORT functionality. The

i-PORT is a low voltage device with no line voltage required.

For a description of the electrical connections refer to Section 2

i-PORT

Terminal Blocks — Brief Description,

and Section 3

System Inputs and

Outputs

. For the specifications on the power supply see Section 8

External Power Supply Requirements

Environment Range

Physical

Dimensions 11.75" x 7.75" x 3.2" (30 x 20 x 8 cm)

Weight 7.5 lbs (3.4 kg)

Operational

Temperature 32° F to 158° F (0° C to 70° C)

Humidity 90% non-condensing

Storage

Temperature -40° F to 185° F (-40° C to 85° C)

Humidit

90% non-condensin