User's Manual

RTLS Hardware and Installation Manual
Page 4 of 30
European Notification according R&TTE Directive
This equipment complies to Art. 6.4 of R&TTE Directive (1999/5/EC). It is tested for compliance with the
following standards: ETSI EN 300 220, ETSI EN 300 440, ETSI EN 301 489, EN 60950.
USA Notification
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The user(s) of these products are cautioned to only use accessories and peripherals approved, in
advance, by IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by
IDENTEC SOLUTIONS, or any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
The device has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.
Canada Certification
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
2.4 GHz:
This device has been designed to operate with the antennas listed below, and having a maximum gain of
6.0 dBi.
Antennas not included in this list or having a gain greater than 6.0 dBi are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms.
916 MHz:
This device has been designed to operate with the antennas listed below, and having a maximum gain of
2.0 dBi. Antennas not included in this list or having a gain greater than 2.0 dBi are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms.
List of antennas:
2.4 GHz: Huber & Suhner 90A-2400/360/6/0/V: 6.0 dBi, 50 ohms
916 MHz: Kathrein K751161: 2.0 dBi, 50 ohms