User's Manual

RTLS Hardware and Installation Manual
Page 26 of 30
In the category “Configuration” chose “Network”. Now adjust the network settings as required. Then
finish by click on “Apply”. Finally, in the category “Administration” choose “Reboot”.
4.4 Status Display (LEDs)
ANT 1: This is the antenna of the 2.45 GHz RTLS part. LED blinks
green when a valid packet has been received. It blinks RED when
a ranging of type 1 has been successfully done.
ANT 2: This is the antenna of the UHF part.
Sending a command: As long as wake up is sent, the ANT2 Led is
green. If a packet is received as a valid answer, goes red. (Give
orange effect).
Beacon receiving: beacon message is detected -> ANT2 goes
green. If this tag is a new tag in the reader’s list, it goes orange.
If it is already in the list it stays green.
RUN: Device is running properly (LED blinks at approx 1 Hz).
BUS: Blinks GREEN when data is received on the i-BUS. Blinks
RED when sending data to the i-BUS.
ERR: Blinks RED when an error occurs.