User's Manual

i-PORT MB – Manual

Version 1.1 02.02.2007 Page 3/

Radio Frequency Compliance Statement

IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices:

MODEL:

i-PORT MB

i-CARD CF

i-B Tags

EUROPE:

The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by

IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by IDENTEC

SOLUTIONS, or unauthorized changes to approved products, may void the compliance of these products and may

result in the loss of the user(s) authority to operate the equipment.

Operation is subject to the following conditions: (1) these devices may not cause harmful interference, and (2)

these devices must accept any interference, including interference that may cause undesired operation of the

device.

European Notification according R&TTE Directive (i-CARD 3 / EU)

This equipment complies to Art. 6.4 of R&TTE Directive (1999/5/EC). It is tested for compliance with the

following standards:

EN 300 220-1 V1.3.1 (2000-09), EN 300 220-3 V1.3.1 (2000-09), ETSI EN 301 489 V1.4.1 (2002-08), ETSI EN

301 489 V1.4.1 (2002-08)

USA Notification

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

FCC- / INDUSTRY-CANADA-NOTICE:

To comply with FCC Part 15 Rules in the United States / with Industry Canada Radio Standard

Specifications in Canada, the system must be professionally installed to ensure compliance with the FCC

Part 15 certification / Industry Canada Radio Standard Specification certification. It is the responsibility of the

operator and professional installer to ensure that only certified systems are deployed in the United States /

Canada. The use of the system in any other combination (such as colocated antennas transmitting the

same information) is expressly forbidden.

CANADA:

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that

the equivalent isotropically radiated power (EIRP) is not more than that permitted for successful

communication.

This device has been designed to operate with the antennas listed below, and having a maximum gain of

3 dBi. Antennas not included in this list or having a gain greater than 3 dBi are strictly prohibited for use with

this device. The required antenna impedance is 50 ohms.

Antenna: RADIAL/LARSEN, Model: SPDA24832 Dipole