User's Manual

i-PORT MB – Manual

Version 1.1 02.02.2007 Page 26/

4.6

Set parameter command

Command telegram

This command is used to initialize and configure the reader. All the parameters and functions are defined in a

sub- command field contained in the telegram.

Parameter Range Length/byte Remark

Start SOH 1

Address 1

Command 0x43 1

SubCmd 1 See table below

Arg 4 See table below. Most

significant byte first.

CRC16 2

End EOT 1

Response telegram

Parameter Range Length/byte

Remark

Start SOH 1

Address 1

Command 0xc3 1

Status 1 Note: 0x00 denotes success, 0x11

Voltage to low to write

CRC16 2

End EOT 1