User's Manual

i-PORT MB – Manual
Version 1.1 02.02.2007 Page 14/ 37
The mounting kit is to be clipped on the back of the i-PORT MB, there is 5 mm space left for the screws
between the mounting kit and the reader.
Use the two mounting holes (diameter 4,5 mm) to attach the i-PORT MB mounting kit to a suitable mounting
surface. Once the mounting kit is fixed, clipped in the i-PORT MB reader.
Please add to the i-PORT MB dimensions approximately 70 mm on the antenna side and 40 mm on the cable
side to calculate the required mounting space. The i-PORT MB weights approx. 150 g.
Enclosure rating is IP40 without the end cap and IP64 with. If greater enclosure rating is required, the i-PORT
MB must be placed in an additional protective housing, in this situation the end cap could be removed.